Reference-based mix analysis
for clearer revisions.
Compare your mix against a reference track, analyze every detail, and get AI-generated feedback you can actually use.
Private & secure: your audio is never shared
Drop
v2Fix firstHold On . Compared to test . Section . Mix 1:29 - 3:53 . Ref 1:22 - 3:40
Analyzed 5 Jun 2026 at 16:36
Main differences vs the reference
On the drop, your mix is off the reference on dynamics and tonal balance. Open the tabs above for the exact measurements.
Fix these first
Mix dynamic range is 3.70 dB above the reference.
Mix low band is 6.4 percentage points above the reference.
Mix high band is 6.1 percentage points below the reference.
Mix is 1.0 dB below the reference.
Your mix sits at -9.9 LUFS against -8.9 LUFS on the reference. Sample peak is 3.0 dBFS, +2.7 dB versus the saved reference peak.
Bring the master level up: your mix is sitting quieter than the reference.
Mix is 3.7 dB more dynamic than the reference.
The dynamic-range comparison puts your mix at 12.9 versus 9.2 on the reference. Per-window punch swings by +/-3.6 dB against +/-3.7 dB on the reference.
Add gentle bus compression or a soft limiter to tighten the loud-quiet swings.
Low +6.4 pp, high -6.1 pp vs the reference.
The band snapshot compares your low, mid and top-end balance against the reference: low end runs heavy while the top end sits dark.
Cut a couple of dB around 60-120 Hz and add gentle air above 8 kHz to match the reference.
Width 5.1% side energy, correlation 0.90, matches the reference.
Mix sits at 5.1% side energy against 5.1% on the reference. L/R correlation is 0.90, so the mono fold-down stays close to the stereo signal.
Stereo image and mono compatibility both track the reference: nothing to change here.
At a Glance
Key metrics vs reference
How it works
Watch a full pass: from upload to clear feedback in minutes.
What we analyze
Every mix is measured across four dimensions: then held up against your reference.
Loudness
Integrated programme loudness and sample-peak headroom, matched against the reference.
Dynamics
Dynamic range and punch: how much life sits between the quiet and loud moments.
Tonal balance
Low, mid and high energy split, so you can see where your mix drifts from the target curve.
Stereo
Stereo width and mono compatibility, checked against the reference and for phase safety.
Version history
Keep every revision. See what changed. Make better decisions.
See where your mix drifts
Loudness, dynamics, tonal balance and stereo, mix overlaid on reference: exactly what you get inside every report.
Compare & decide
A/B any version against your reference or another mix.
Start free. Upgrade when you are ready.
Analyze a mix against a reference at no cost. Go Premium for full-track depth, saved history, and priority processing.
Free
Everything you need to get objective feedback on a single mix.
Start freePremium
Save 37%Billed annually at $99 . or $12.99 billed monthly
Start 7-day free trial->Private trial . Cancel anytime
Start with one mix.
Upload a track, add a reference,
and get a clearer path to your next revision.